Well went for a ride today. My clutch was slipping a little and hard to start. So, I choked it and got it running. Cruising’ around my apts and went around the corner. Tried to pull clutch in and nothing. Just rode it for a little while and limped it back to my apts. I thought my clutch cable slipped but no. Clutch arm wasn’t making contact with bucking bar. Tried different bucking bars still no contact. Ball bearing was in there. Wierd! Took whole clutch shaft out and found this. Pin broke in half for holding preload spring in place. Someone suggested I find a drill bit same size and cut end off solid side to make that fit. I think I’m going to do that instead of buying a whole new clutch shaft. At least I found the problem! #parts #diy #80cc #80ccgasbike #motoredlife #bikelife #bikelifetexas #gaspoweredbike #gaspoweredbicycles #gasframe #gasbike #gasbikes #gasbicycle #gasbicycles #motorizedbike #motorizedbikes #motorizedbicycle #motorizedbicycles